The newest profile from the SENTIR range of edges. Perfect for hinge gap protection but also with better over travel distance or ‘crushing’ of the profile compared to the SKL15-10 edge.
This is a CLIP ON, T FOOT edge, part of the SENTIR range. The aluminum is visible after installation. This profile is available to purchase in 25m rolls and assemble yourself, or give us your edge requirements and we will per-assemble the edge(s) for you.
This profile is our recommended profile for smaller gates and areas such as hinge gap protection. This is because of the superior quality over the SKL15-10 egde as well as the ease of installation thanks to the ‘CLIP ON’ resistor and cable ends.
This profile uses the AL15-9 aluminum edge as detailed below – for further technical data and dimensions, see documents above.
GF15.25/mtr – GF15.25 – 25mm (thin) Safety edge rubber profile | This profile is available in 30m rolls
AL15-9 – AL15-9 – Aluminium for GF15.25 profile | Available in max 2.5m lengths
KS4W-15.25 – KS4W-15.25 8.2Kohm resistor for GF15.25 profile – includes end cap
KS4L2.5m-15.25 – KS4L2.5m-15.25 Cable end 2.5m of cable – includes end cap
Pre made safety edges
Give us the length and profile that you require and we will make your ASO resistive edges for you and send to your address, or even to site.
Order the following codes for pre-made safety edges (GF15.25 25mm (thin) profile):
GF15.251.0m – Up to 1.0m 25mm (thin) profile safety edge – res or thru
GF15.251.5m – Up to 1.5m 25mm (thin) profile safety edge – res or thru
GF15.252.0m – Up to 2.0m 25mm (thin) profile safety edge – res or thru
GF15.252.5m – Up to 2.5m 25mm (thin) profile safety edge – res or thru
GF15.253.0m – Up to 3.0m 25mm (thin) profile safety edge – res or thru
*Longer sizes are available on special request